TEL: +86-21-51093886,58161171,58162171

FAX: +86-21-51862296



Factory address: 199-6 Luji Road, Pudong, Shanghai 201322, China


you are here:Home > problem

We've been using small diameter drills (less or equal the diameter 0.5) so far. What's the point for preventing the breakage?

Time:2014/5/24 15:25:00 click:757times

We recommend to set the run-out of tools less or equal 5µm. If the diameter is smaller, the effective will be more. And, we also recommend making use of our measuring equipment to check the run-out of tools during the revolution (dynamic run-out). It's possible to lend the equipment for demonstration.

Bottom navigation: Home | About Us | Products | News | FAQ | Contact

Products Recommend: End mills|Solid carbide drills|Single flute End Mills|Roughing End Mills|Hogging End Mills|End mills for Woodworking|End Mills for Graphite|

Micro End Mills|End Mills for Aluminium|End mills for Stainless Steel|HSS END MILLS|Spot Drills|Solid Carbide Rougher|Step Drills|Tapered Corner Radius

CGI (SHANGHAI) LTD Copyright © 2011-2014, All Rights Reserved Technical support: Hangzhou Sixi